Administrator Guide

164432 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 4985572 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 5150004 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
11165065 packets, 714564160 bytes, 0 underruns
11165065 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
309 Multicasts, 0 Broadcasts, 11164756 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 140.00 Mbits/sec, 18070 packets/sec, 14.30% of line-rate
Output 20.00 Mbits/sec, 39175 packets/sec, 2.60% of line-rate
Time since last interface status change: 02:37:06
Related
Commands
show interfaces — displays the interface configuration.
interface loopback
Configure a Loopback interface.
C9000 Series
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
number Enter a number as the interface number. The range is from 0 to 16383.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Example
Dell(conf)# interface loopback 1655
Dell(conf-if-lo-1655)#
Related
Commands
interface — configures a physical interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
692 Interfaces