Administrator Guide

Version Description
6.2.1.0 Introduced
Example (Single
Range)
This example displays the macro named test.
Dell(config)# interface range macro test
Dell(config-if-range-te-0/0-3,te-1/0-47,te-2/0-89)#
Dell
Related
Commands
• interface range — configures a range of command (bulk configuration).
• interface range macro (define) — defines a macro for an interface range (bulk configuration).
interface vlan
Configure a VLAN. You can configure up to 4094 VLANs.
C9000 Series
Syntax
interface vlan vlan-id
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is 1 to 4094.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.0(1.3) Introduced on the S5000.
Usage Information
For more information about VLANs and the commands to configure them, refer to the Virtual LAN (VLAN)
Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP ACLs
are supported. For more information, refer to the Access Control Lists (ACL) chapter.
Example (Single
Range)
Dell(conf)# int vlan 3
Dell(conf-if-vl-3)#
Related
Commands
• interface – configures a physical interface.
• interface loopback – configures a loopback interface.
• interface null – configures a null interface.
• interface port-channel – configures a port channel group.
• show vlan – displays the current VLAN configuration on the switch.
• shutdown – disables/enables the VLAN.
• tagged – adds a Layer 2 interface to a VLAN as a tagged interface.
• untagged – adds a Layer 2 interface to a VLAN as an untagged interface.
keepalive
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
C9000 Series
Syntax
keepalive [seconds]
Interfaces 699