Administrator Guide

Parameters
process-id Enter a number that corresponds to the OSPF process ID to be redistributed. The range is
from 1 to 65355.
metric metric-
value
(OPTIONAL) The value used for the redistributed route. Use a metric value that is
consistent with the destination protocol. The range is from 0 to 16777215. The default is
0.
metric-type
{external |
internal}
(OPTIONAL) The external link type associated with the default route advertised into a
routing domain. The two options are:
• external
• internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes. This
setting is the default.
match {external |
internal}
(OPTIONAL) The command used for OSPF to route and redistribute into other routing
domains. The values are
• internal
• external
route-map map-
name
map-name is an identifier for a configured route map. The route map should filter
imported routes from the source routing protocol to the current routing protocol.
If you do not specify a map-name, all routes are redistributed. If you specify a keyword,
but fail to list route map tags, no routes are imported.
Defaults Refer to Parameters.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage Information
How a metric value assigned to a redistributed route is advertised depends on how on the configuration of the
metric-style command. If the metric-style command is set for Narrow mode and the metric value in the
redistribute ospf command is set to a number higher than 63, the metric value advertised in LSPs is 63. If
the metric-style command is set for wide mode, the metric value in the redistribute ospf command is
advertised.
818 Intermediate System to Intermediate System (IS-IS)