Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON. Maximum range of the Hello interval value is changed to
18000.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.
E-Series legacy
command.
Usage Information
If you have configured the hello interval value to be greater than 18000, you must first reset that value to be less
than or equal to 18000 before upload. Otherwise, the command execution fails during bootup and the hello interval
value is set to the default value.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
C9000 Series
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time command.
Parameters
seconds Enter the number of seconds for the maximum response time. The range is from 1 to 25.
The default is 10 seconds.
Defaults 10 seconds
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
840 Internet Group Management Protocol (IGMP)