Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

851

852

853

854

855

856

857

858

859

860

To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier

command.

Defaults Not configured.

Command Modes

INTERFACE

INTERFACE (BATCH Mode)

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux

(PMUX) mode only.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

Usage Information

This command enables the IGMP switch to send General Queries periodically. This behavior is useful when there is

no multicast router present in the VLAN because the multicast traffic is not routed. Assign an IP address to the

VLAN interface for the switch to act as a querier for this VLAN.

show ip igmp snooping mrouter

Display multicast router interfaces.

C9000 Series

Syntax

show ip igmp snooping mrouter [vlan number]

Parameters

vlan

number

Enter the keyword vlan then the vlan number. The range is from 1 to 4094.