Administrator Guide

to 14.4.4.2
00:12:42 : %RELAY-I-PACKET: BOOTP REPLY (Unicast) received at interface
14.4.4.1 BOOTP Reply,
hops = 0, XID = 0xda4f9503, secs = 0, hwaddr = 00:60:CF:20:7B:8C, teaddr =
113.3.3.17
00:12:42 : %RELAY-I-BOOTREPLY: Forwarded BOOTREPLY for 00:60:CF:20:7B:8C to
113.3.3.254
Dell#
Related
Commands
• ip helper-address – specifies the destination broadcast or host address for the DHCP server request.
• ip helper-address hop-count disable – disables the hop-count increment for the DHCP relay agent.
debug ip icmp
View information on the internal control message protocol (ICMP).
C9000 Series
Syntax
debug ip icmp [interface] [count value]
To disable debugging, use the no debug ip icmp command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For the Management interface, enter the keyword ManagementEthernet then the
slot/port information. The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a Tunnel interface, enter the keywords tunnel then a number. The range is from
1 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id/stack-unit/port information.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
count value (OPTIONAL) Enter the keyword count then the count value. The range is from 1 to
65534. The default is Infinity.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
874 IPv4 Routing