Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

901

902

903

904

905

906

907

908

909

910

Version Description

9.11(0.0) Updated the command output to include the unicast reverse path forwarding (uRPF)

status.

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

8.3.7.0 Introduced on the S4810.

8.1.1.2 Supported on the E-Series ExaScale E600i.

8.1.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.0 Introduced on the E-Series.

Usage Information The following describes the show ip interface command shown in the following example.

Lines Description

TenGigabitEthern

et 0/0...

Displays the interface’s type, slot/port, and physical and line protocol status.

Internet address... States whether an IP address is assigned to the interface. If an IP address is assigned,

that address is displayed.

IP MTU is... Displays IP MTU value.

Inbound access... Displays the name of the configured incoming access list. If none is configured, the phrase

“not set” is displayed.

Proxy ARP... States whether proxy ARP is enabled on the interface.

Split horizon... States whether split horizon for RIP is enabled on the interface.

Poison Reverse... States whether poison for RIP is enabled on the interface.

ICMP redirects... States if ICMP redirects are sent.

ICMP

unreachables...

States if ICMP unreachable messages are sent.

Example

Dell# show ip interface tengigabitethernet 2

TenGigabitEthernet 2/0 is down, line protocol is down

Internet address is not set

IP MTU is 1500 bytes

Directed broadcast forwarding is disabled

Proxy ARP is enabled

Split Horizon is enabled

Poison Reverse is disabled

ICMP redirects are not sent

ICMP unreachables are not sent

IP unicast RPF check is not supported

TenGigabitEthernet 2/1 is down, line protocol is down