Users Guide

• (From a Dell Networking system) Identify the system manager along with this person’s contact information
(for example, an email address or phone number).
CONFIGURATION mode
snmp-server contact text
You may use up to 55 characters.
The default is None.
• (From a Dell Networking system) Identify the physical location of the system (for example, San Jose, 350
Holger Way, 1st floor lab, rack A1-1).
CONFIGURATION mode
snmp-server location text
You may use up to 55 characters.
The default is None.
• (From a management station) Identify the system manager along with this person’s contact information
(for example, an email address or phone number).
CONFIGURATION mode
snmpset -v version -c community agent-ip sysContact.0 s “contact-info”
You may use up to 55 characters.
The default is None.
• (From a management station) Identify the physical location of the system (for example, San Jose, 350
Holger Way, 1st floor lab, rack A1-1).
CONFIGURATION mode
snmpset -v version -c community agent-ip sysLocation.0 s “location-info”
You may use up to 55 characters.
The default is None.
Configuring the CPU Utilization for
SNMP Traps
When the total CPU utilization exceeds the configured threshold for the specified time, a threshold
notification is sent as an SNMP trap. If a low threshold value is not specified, the low threshold value is set to
the same value as the high threshold value. The system generates a Syslog and SNMP trap each time the
configured CPU threshold is crossed.
NOTE
: The 5 sec util-threshold cpu command is disabled by default on all switches. To enable the
command, enter the util-threshold cpu 5sec all high {value greater than zero}. To disable the
Syslog and traps for the 5 sec CPU utilization thresholds, enter the
util-threshold cpu 5sec all
high 0 or no util-threshold cpu 5sec {cp | rp | lp slot-id | all} command.
Simple Network Management Protocol (SNMP) 1047