Users Guide

Task Command Syntax Command Mode
Configure a static route that points
to a management interface.
management route ip-
address mask
managementethernet
ormanagement route ipv6-
address prefix-length
managementethernet
NOTE: You can also have
the management route to
point to a front-end port in
case of the management
VRF. For example:
management route 2::/64 te
0/0.
CONFIGURATION
To configure a static entry in the IPv6 neighbor discovery, perform the following steps:
Task Command Syntax Command Mode
Configure a static neighbor. CONFIGURATION
Route Leaking VRFs
Static routes can be used to redistribute routes between non-default to default/non-default VRF and vice-
versa.
NOTE: Route leaking VRFs are supported only for IPv4 routes.
You can configure route leaking between two VRFs using the following command: ip route vrf x.x.x.x
s.s.s.s nh.nh.nh.nh vrf default.
This command indicates that packets that are destined to x.x.x.x/s.s.s.s are reachable through
nh.nh.nh.nh in the default VRF table. Meaning, the routes to x.x.x.x/s.s.s.s are leaked from the
default VRF routing table into the non-default VRF routing table.
The following example illustrates how route leaking between two VRFs can be performed:
interface TenGigabitEthernet 0/9
ip vrf forwarding VRF1
ip address 120.0.0.1/24
interface TenGigabitEthernet 0/10
ip vrf forwarding VRF2
ip address 140.0.0.1/24
ip route vrf VRF1 20.0.0.0/16 140.0.0.2 vrf VRF2
ip route vrf VRF2 40.0.0.0/16 120.0.0.2 vrf VRF1
Virtual Routing and Forwarding (VRF) 1158