Users Guide

3 Linecard online C9000LC2410T C9000LC2410T 1-0(0-4095) 24
4 Linecard online C9000LC0640 C9000LC0640 1-0(0-4095) 24
5 Linecard online C9000LC0640 C9000LC0640 1-0(0-4095) 24
6 Linecard online C9000LC0640 C9000LC0640 1-0(0-4095) 24
7 Linecard online C9000LC0640 C9000LC0640 1-0(0-4095) 24
8 Linecard online C9000LC2410G C9000LC2410G 1-0(0-4095)
24
9 Linecard online C9000LC2410G C9000LC2410G 1-0(0-4095)
24
10 Linecard online C9000-RPM-2.56T C9000-RPM-2.56T
1-0(0-4095) 4
11 Linecard online C9000-RPM-2.56T C9000-RPM-2.56T
1-0(0-4095) 4
Pre-configuring a Slot for a Line-Card Type
You can pre-configure an empty line-card slot with a logical line card by using the linecard slot-id
provision card-type command. After you create the logical line card, you can configure interfaces on
the line card as if it is present in the chassis. If the card fails, the system maintains the logical configuration for
the slot.
The C9010 supports the following line cards and card types:
• 6-Port 40 Gigabit Ethernet QSFP+ (card type: C9000LC0640)
• 24-Port 1/10 Gigabit Ethernet SFP+ (card type: C9000LC2410G)
• 24-Port 1/10 Gigabit Ethernet Base-T RJ-45 (card type: C9000LC2410T)
Dell(conf)# linecard 3 provision C9000LC2410G
Dell(conf)# end
Dell# show linecard 3
-- Linecard 3 --
Status : not present
Required Type : C9000LC2410G - 24-port TE/GE
Replacing a Line Card
To replace a line card with a line card of the same type, you can remove the old card and insert a new card
without any additional configuration.
To replace a line card with a different card type, remove the card and then remove the existing line-card
configuration for the slot using the command no linecard slot-id provision.
Dell(conf)# no linecard 3 provision
If you do not remove the existing line-card configuration, the status of the newly installed line card displays as
mismatch card type.
Dell# show linecard 5
-- Linecard 5 --
Status : type mismatch - mismatch card type
Next Boot : online
Required Type : C9000LC2410G - 24-port TE/GE
High Availability (HA) 470