Users Guide
• Create a Rule for a Redirect-list
• Create a Track-id list. For complete tracking information, refer to Object Tracking chapter.
• Apply a Redirect-list to an Interface using a Redirect-group
Create a Redirect List
Use the following command in CONFIGURATION mode:
Table 62. Create a Redirect List
Command Syntax Command Mode Purpose
ip redirect-list redirect-list-
name
CONFIGURATION Create a redirect list by entering the list name.
Format: 16 characters
Delete the redirect list with the no ip redirect-list command.
The following example creates a redirect list by the name of “xyz.”
Dell(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
Dell(conf)#ip redirect-list xyz
Create a Rule for a Redirect-list
Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the redirect list.
You can enter the command multiple times and create a sequence of redirect rules. Use the
seq nn redirect
version of the command to organize your rules.
Table 63. Create a Rule for a Redirect-list
Command Syntax Comma
nd
Mode
Purpose
{seq sequence-
number} redirect
{ip-address|
tunnel tunnel-id}
[track obj-id]
{protocol-type}
{source mask | any
| host ip-address}
{destination mask
| any | host ip-
address} [bit]
[operators]}
REDIRE
CT-LIST
Configure a rule for the redirect list.
ip-address is the forwarding router’s address
tunnel — keyword to configure the tunnel settings.
tunnel-id is used to redirect the traffic.
Protocol-type — Enter one of the following keywords as the protocol
type
• icmp for Internet Control Message Protocol
• ip for Any Internet Protocol
• tcp for Transmission Control Protocol
• udp for User Datagram Protocol
Optional
Policy-based Routing (PBR) 807