Administrator Guide

● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
output-range
interface
For a multicast MAC address, enter the keyword output-range then one of the
following interfaces to indicate a range of ports for which traffic is forwarded:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not configured.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1(0.0) Added support for output range parameter for S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
(Unicast)
mac-address-table static 00:01:00:00:00:01 {output Te 0/2 vlan 2}
Example
(Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range
Te 0/2,Te 0/3}
Related
Commands
show mac-address-table — displays the MAC address table.
1012 Layer 2