Administrator Guide

T Po20(Te 1/81)
T Fo 2/0
Example (Brief)
Dell#show vlan brief
VLAN Name STG MAC Aging IP Address
---- -------------------------------- ---- --------- ------------------
1 0 1800 unassigned
10 0 1800 unassigned
20 0 1800 2.3.3.3/24
30 0 1800 2.1.1.1/24
Example (Name)
Dellconf)#interface vlan 20
Dell(conf-if-vl-20)#name test
Dell(conf-if-vl-20)#do show vlan name test
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring
VLANs, P - Primary, C - Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT
tagged
NUM Status Description Q Ports
20 Active T Po10(Te 0/140,Te
1/80)
T Po20(Te 1/81)
T Fo 2/0
Related
Commands
interface vlan — configures a VLAN.
tagged
Add a Layer 2 interface to a VLAN as a tagged interface.
C9000 Series
Syntax
tagged interface
To remove a tagged interface from a VLAN, use the no tagged interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
1030 Layer 2