Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
port-channel mode
Configure the LACP port channel mode.
C9000 Series
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active state.
NOTE: LACP modes are defined in Usage Information.
passive Enter the keyword passive to set the mode to the passive state.
NOTE: LACP modes are defined in Usage Information.
off Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information.
Defaults off
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
LACP Modes
Link Aggregation Control Protocol (LACP) 1045