Administrator Guide

To return to the default multiplier value, use the no pe-lldp-multiplier command.
Parameters
number Modify the number to change the PE LLDP multiplier value. The range is from 3 to
10.
Defaults 3
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.6) Introduced on the C9010.
Usage
Information
PE LLDP timeout is based on the hello interval and multiplier value (for example: Default Hello interval: 3
seconds * multiplier: 3 seconds). This command allows you to change the multiplier value only.
Example
(configure the
PE LLDP
multiplier)
DellEMC(conf)#pe-lldp-multiplier ?
<3-10> Multiplier value (default = 3)
DellEMC(conf)#pe-lldp-multiplier 5
DellEMC(conf)#
DellEMC(conf)#do show running-config | grep pe-
pe-lldp-multiplier 5
DellEMC(conf)#
Example
(unconfigure the
PE LLDP
multiplier)
DellEMC(conf)#no pe-lldp-multiplier
DellEMC(conf)#
DellEMC(conf)#do show running-config | grep pe-
DellEMC(conf)#
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
C9000 Series
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command Modes
CONFIGURATION(conf-lldp)
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
1060 Link Layer Discovery Protocol (LLDP)