Administrator Guide

advertise med guest-voice
To advertise a separate limited voice service for a guest user with their own IP telephony handset or other appliances that
support interactive voice services, configure the system.
C9000 Series
Syntax
advertise med guest-voice {vlan-id layer2_priority DSCP_value} | {priority-
tagged number}
To return to the default, use the no advertise med guest-voice {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged followed the Layer 2 priority. The range is
from 0 to 7.
Defaults Unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med guest-voice-signaling
To advertise a separate limited voice service for a guest user when the guest voice control packets use a separate network
policy than the voice data, configure the system.
C9000 Series
Syntax
advertise med guest-voice-signaling {vlan-id layer2_priority DSCP_value} |
{priority-tagged number}
1068 Link Layer Discovery Protocol (LLDP)