Administrator Guide

ip multicast-routing
Enable IP multicast forwarding.
C9000 Series
Syntax
ip multicast-routing
To disable multicast forwarding, use the no ip multicast-routing command.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage
Information
After you enable multicast, you can enable IGMP and PIM on an interface. In INTERFACE mode, enter the
ip pim sparse-mode command to enable IGMP and PIM on the interface.
Related
Commands
ip pim sparse-mode — enables IGMP and PIM on an interface.
show ip multicast-cam
Display the content addressable memory (CAM) size and the portions allocated for IP multicast traffic.
Syntax
show ip multicast-cam linecard slot-id port-set port-pipe
Parameters
linecard slot-id Enter the keyword linecard with a slot number to select the line card for which
to gather information. The range of Z9500 slot IDs is from 0 to 2.
port-set port-
pipe
Enter the keyword port-set with a port-pipe number to select the port pipe for
which to gather information. The range of port pipes is from 0 to 3.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
1080 Multicast