Administrator Guide

Example
Dell#show ip rpf
RPF information for 10.10.10.9
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
IPv6 Multicast Commands
The following section contains the IPv6 multicast commands.
clear ipv6 mroute
Clear learned multicast routes on the multicast forwarding table.
Syntax
clear ipv6 mroute [vrf vrf-name] {group-address [source-address] | *}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure
this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
group-address
[ source-address ]
Enter the multicast group address and source address (if desired), in dotted
decimal format, to clear information on a specific group.
* Enter * to clear all multicast routes.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11.3.0 Introduced on the C9000, S3048–ON, S3100, S4048–ON, S4048T-ON, S6000–
ON, S6010–ON, S6100–ON and Z9100–ON.
Related
Commands
● show ip pim tib — show the PIM tree information base.
ipv6 multicast-routing
Enables IPv6 multicast forwarding.
Syntax
ipv6 multicast-routing [vrf vrf-name]
To disable multicast forwarding, use the no ipv6 multicast-routing [vrf vrf-name]
command.
Defaults Disabled.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable IP
multicast forwarding on that VRF.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
1084 Multicast