Administrator Guide

Parameters
group-address Enter the group IP address in dotted decimal format (A.B.C.D.).
rejected-sa Enter the keyword rejected-sa to clear the cache source-active entries that
are rejected because the RPF check failed, an SA filter or limit is configured, the
RP or MSDP peer is unreachable, or because of a format error.
local Enter the keyword local to clear out local PIM advertised entries. It applies the
redistribute filter (if present) while adding the local PIM SA entries to the SA
cache.
Defaults Without any options, this command clears the entire source-active cache.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
7.8.1.0 Added the local option.
7.7.1.0 Added the rejected-sa option.
6.2.1.1 Introduced
debug ip msdp
Turn on MSDP debugging.
C9000 Series
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address | packet peer
address | pim} command.
Parameters
event peer
address
Enter the keyword event then the peer address in a dotted decimal format
(A.B.C.D.).
packet peer
address
Enter the keyword packet then the peer address in a dotted decimal format
(A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Defaults Not configured.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1100 Multicast Source Discovery Protocol (MSDP)