Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1131

Defaults None

Command Modes POLICY LIST CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.11(0.0) Introduced on the C9010.

9.9(0.0) Introduced on the Z9500.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9000

switches.

Commands

● ipv6 nd ra-guard enable — configure the RA guard related commands.

● ipv6 nd raguard policy policy-name — define the router advertisement (RA) guard policy name and

enter the RA guard policy configuration mode.

router–preference maximum

Enable the verification of the advertised default router preference (DRP) value. The preference value is lower than or equal to

the specified limit. If this command is not configured, the verification process is bypassed.

Syntax

router-preference maximum {high | low | medium}

To reset the default router preference value, use the no router-preference maximum {high |

low | medium} command.

Parameters

high Enter the keyword high to set the DRP value as high.

low Enter the keyword low to set the DRP value as low.

medium Enter the keyword medium to set the DRP value as medium.