Administrator Guide

Object Tracking
Object Tracking supports IPv4 and IPv6 protocols.
Object tracking allows you to define objects of interest, monitor their state, and report to a client when a change in an object’s
state occurs. The following tracked objects are supported:
● Link status of Layer 2 interfaces
● Routing status of Layer 3 interfaces (IPv4 and IPv6)
● Reachability of IPv4 and IPv6 routes
● Metric thresholds of IPv4 and IPv6 routes
You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a notification when the state
of a tracked object changes.
This chapter contains the following sections:
● IPv4 Object Tracking Commands
● IPv6 Object Tracking Commands
Topics:
• IPv4 Object Tracking Commands
• IPv6 Object Tracking Commands
IPv4 Object Tracking Commands
The following section describes the IPv4 object tracking commands.
debug track
Enable debugging for tracked objects.
C9000 Series
Syntax
debug track [all | notifications | object-id]
Parameters
all Enables debugging on the state and notifications of all tracked objects.
notifications Enables debugging on the notifications of all tracked objects.
object-id Enables debugging on the state and notifications of the specified tracked object.
The range is from 1 to 500.
Defaults Enable debugging on the state and notifications of all tracked objects (debug track all).
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
38
1138 Object Tracking