Administrator Guide

IPv6 Object Tracking Commands
The following section describes the IPv6 object tracking commands.
The following object tracking commands apply to IPv4 and IPv6:
● debug track
● delay
● description
● show running-config track
● threshold metric
● track interface line-protocol
show track ipv6 route
Display information about all tracked IPv6 routes, including configuration, current tracked state (UP or DOWN), and the clients
which are tracking an object.
C9000 Series
Syntax
show track ipv6 route [brief]
Parameters
brief (OPTIONAL) Display a single line summary of information for tracked IPv6 routes.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Command The following table describes the show track ipv6 route command shown in the following example.
Output Description
Track object-id Displays the number of the tracked object.
Interface type
slot/port , IP
route ip-address ,
IPv6 route ipv6-
address
Displays the interface type and slot/port number or address of the IPv4/IPv6 route
that is being tracked.
object is Up/
Down
Up/Down state of tracked object; for example, IPv4 interface, reachability, or
metric threshold of an IP route.
number changes,
last change time
Number of times that the state of the tracked object has changed and the time
since the last change in hours:minutes:seconds.
First hop
interface
Displays the type and slot/port number of the first-hop interface of the tracked
route.
1150 Object Tracking