Administrator Guide

Parameters
object-id Enter the ID number of the tracked object. The range is from 1 to 500.
interface Enter one of the following values:
● For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage
Information
Use this command to create an object that tracks the routing state of an IPv6 Layer 3 interface:
● The status of the IPv6 interface is UP only if the Layer 2 status of the interface is UP and the
interface has a valid IP address.
● The Layer 3 status of an IPv6 interface goes DOWN when its Layer 2 status goes down (for a Layer 3
VLAN, all VLAN ports must be down) or the IP address is removed from the routing table.
Related
Commands
● show track ipv6 route – displays information about tracked IPv6 routes, including configuration,
current state, and clients which track the route.
● track interface ip routing – configures object tracking on the routing status of an IPv4 Layer 3
interface.
track ipv6 route metric threshold
Configure object tracking on the threshold of an IPv4 route metric.
C9000 Series
Syntax
track object-id ipv6 route ipv6-address/prefix-len metric threshold
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is from 1 to 500.
ipv6-address/
prefix-len
Enter an IPv6 address in X:X:X:X::X format. The valid IPv6 prefix lengths are
from /0 to / 128.
1152 Object Tracking