Administrator Guide

distribute-list in
Apply a filter to incoming routing updates from OSPF to the routing table.
C9000 Series
Syntax
distribute-list prefix-list-name in [interface]
To delete a filter, use the no distribute-list prefix-list-name in [interface]
command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Enter one of the following keywords and slot/port or number
information:
● For Port Channel groups, enter the keywords port-channel then a number.
The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
Defaults Not configured.
Command Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
distribute-list out
To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
C9000 Series
Syntax
distribute-list prefix-list-name out [bgp | connected | isis | rip |
static]
To remove a filter, use the no distribute-list prefix-list-name out [bgp | connected
| isis | rip | static] command.
Open Shortest Path First (OSPFv2 and OSPFv3) 1169