Administrator Guide

For MD5 authentication, the key must be 32 hex digits (non-encrypted) or 64 hex
digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-encrypted) or 80 hex
digits (encrypted).
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on S4810 and Z9000.
8.4.2.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage
Information
Before you enable IPsec authentication on an OSPFv3 interface, first enable IPv6 unicast routing globally,
configure an IPv6 address and enable OSPFv3 on the interface, and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the router.
Configure the same authentication policy (same SPI and key) on each OSPFv3 interface in a link.
To remove an IPsec authentication policy from an interface, enter the no ipv6 ospf authentication spi
number command. To remove null authentication on an interface to allow the interface to inherit the
authentication policy configured for the OSPFv3 area, enter the no ipv6 ospf authentication
null command.
Related
Commands
area authentication – configures an IPsec authentication policy for an OSPFv3 area.
show crypto ipsec policy – displays the configuration of IPsec authentication policies.
show crypto ipsec sa ipv6 – displays the security associations set up for OSPFv3 interfaces in
authentication policies.
ipv6 ospf bfd all-neighbors
Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session parameters.
C9000 Series
Syntax
ipv6 ospf bfd all-neighbors [disable | [interval interval min_rx min_rx
multiplier value role {active | passive}]]
To disable all BFD sessions on an OSPFv3 interface implicitly, use the no ipv6 ospf bfd all-
neighbors disable command in interface mode..
Parameters
disable (OPTIONAL) Enter the keyword disable to disable BFD on this interface.
interval
milliseconds
(OPTIONAL) Enter the keyword interval to specify non-default BFD session
parameters beginning with the transmission interval. The range is from 50 to 1000.
The default is 200.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at which the local system
receives control packets from the remote system. The range is from 50 to 1000.
The default is 200.
Open Shortest Path First (OSPFv2 and OSPFv3) 1237