Administrator Guide

ipv6 ospf hello-interval
Specify the time interval between the hello packets sent on the interface.
C9000 Series
Syntax
ipv6 ospf hello—interval seconds
To return to the default time interval, enter no ipv6 ospf hello—interval.
Parameters
seconds
Enter the time interval in seconds as the time between hello packets. The range is
from 1 to 65525 seconds.
Defaults 10 seconds (Ethernet).
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage
Information
The time interval between hello packets must be the same for routers in a network.
Related
Commands
ipv6 ospf dead-interval – specifies the time interval between hello packets was received from a router.
ipv6 ospf mtu-ignore
Disable OSPF MTU mismatch detection on receipt of database description (DBD) packets.
Syntax
ipv6 ospf mtu-ignore
To return to the default, use the no ipv6 ospf mtu-ignore command.
Defaults Disabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(2.3) Introduced on the C9000, S3048-ON, S3100, S4048-ON, S4048T-ON, S6000, and
Z9100-ON.
1242 Open Shortest Path First (OSPFv2 and OSPFv3)