Administrator Guide

Diagnostics
Proceed with Diags [confirm yes/no]: yes
Dell#Jun 25 05:15:14: %PE-UNKN-C1048P:3 %DIAGAGT-6-DA_DIAG_STARTED:
Starting diags on stack-unit 3
14:19:49 : Approximate time to complete the Diags (level0)... 2 Mins
Related
Commands
● diag — run diagnostic tests on an offline switch.
● offline — places the stack-unit in the offline state to run the diagnostics tests.
power-cycle
Power-cycle the port extender (PE) stack-unit from the PE console
C9000 Series
Syntax
power-cycle stack-unit {unit-number | all }
Parameters
unit-number Enter a stack-unit number. Range is from 0 to 7.
all Enter all to power-cycle all the stack-units.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 and C1048P.
Usage
Information
CAUTION: Do not attempt to reset or power cycle when the system is going through the
process of upgrading.
Example
Dell#power-cycle ?
stack-unit Stack-unit
Dell#power-cycle stack-unit ?
<0-7> Unit number
all Entire stack
Dell#power-cycle stack-unit 0
Dell#power-cycle stack-unit all ?
show control-bridge status
Display the status of the control bridge from the port extender (PE) console.
C9000 Series
Syntax
show control-bridge status
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command-Line Reference Guide.
PE Console Commands 1261