Administrator Guide

Field Description
DR Prio Displays the Designated Router priority value configured on the interface (use the
ip pim dr-priority command).
DR Displays the IP address of the Designated Router for that interface.
The show ip pim interface command does not display information corresponding to the loop-back
interfaces.
Example
Dell#show ip pim interface
Address Interface Ver/ Nbr Query DR DR
Mode Count Intvl Prio
172.21.200.254 Te 0/9 v2/S 0 30 1 172.21.200.254
172.60.1.2 Te 0/11 v2/S 0 30 1 172.60.1.2
192.3.1.1 Te 0/16 v2/S 1 30 1 192.3.1.1
192.4.1.1 Te 1/5 v2/S 0 30 1 192.4.1.1
172.21.110.1 Te 1/6 v2/S 0 30 1 172.21.110.1
172.21.203.1 Te 1/7 v2/S 0 30 1 172.21.203.1
show ip pim neighbor
View PIM neighbors.
C9000 Series
Syntax
show ip pim neighbor
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip pim neighbor command shown in the following example.
Field Description
Neighbor address Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID (VLAN or Port
Channel), on which the PIM neighbor was found.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time
until the neighbor is removed from the multicast routing table (that is, until the
neighbor hold time expires).
PIM-Sparse Mode (PIM-SM) 1319