Administrator Guide

Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
(20.10.4.9, 225.1.1.2), uptime 00:06:21, expires 00:02:06, flags: CT
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
show running-config pim
Display the current configuration of PIM-SM snooping.
C9000 Series
Syntax
show running-config pim
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Introduced on the E-Series ExaScale.
Example
Dell#show running-config pim
!
ip pim snooping enable
IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
clear ipv6 pim tib
Clear the IPv6 PIM multicast-routing database (tree information base—TIB).
Syntax
clear ipv6 pim [vrf vrf-name] tib [group-address]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure
this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
group-address (OPTIONAL) Enter the multicast group address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
PIM-Sparse Mode (PIM-SM) 1325