Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010.
show config
Display the PE provision configuration details.
C9000 Series
Syntax
show config
Command Modes PE CONFIG (conf-pe-pe-id)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Example
Dell(conf-pe-5)# show config
!
pe provision 5
stack-unit 4 type C1048P
Dell(conf)#pe 255
Dell(conf-pe-255)#show config
!
pe provision 255
cascade interface TenGigabitEthernet 6/0
stack-unit 1 type C1048P
show ecid
Display the E-Channel identifier (ECID) information for all or any specified interfaces.
C9000 Series
Syntax
show ecid {interface [interface] | pe pe-id stack—unit unit-number}
Parameters
interface
interface
Enter the interface keyword, and specify one of the following interface types:
● For a PE Gigabit Ethernet interface, enter the keyword peGigE. You must
specify a pe-id/stack-unit/port-id for the interface.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
1354 Port Extenders (PE)