Administrator Guide

PE-CSP Tx Message: 9
PE-CSP Rx Message: 5
ECP Tx: 10
ECP Rx Ack: 10
ECP Dropped: 0
ECP Rx: 6
ECP Tx Ack: 6
Dell#
Dell#show pe 1
Codes: A - Active, I - Inactive
SVC - Software Version Compatible
Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch
SVM - Software Version Mismatch, UE - Unknown Error
Offline Reason: UNP - Unit Not Present, PVE - Port Validation Error
ICE - IPC CP Error, IRE - IPC RP Error
ISE - IPC Setup Error, CVE - Card Validation Error
PE-ID assigned: 1
Status: online
System Mac: f8:b1:56:73:a2:91
PE Up Time: 03:00:27
PE Description:
PE Discovery Status: Provisioned PE
User Configured Cascade Ports: Te 0/16(A)
Cascade LAG: Po 259, Local Status: Up, Remote Status: Down
PE Configuration: Local Status: Present, Remote Status: Not Present
------------------------------------------------------------------------------
Stack-id Status Reason Type UnitMac No. of Ports Description
------------------------------------------------------------------------------
0 online - N2048P-PE f8:b1:56:73:a2:91 52
1 online - N2048P-PE f8:b1:56:73:a2:89 52
2 online - N3024P-PE f4:8e:38:02:b1:43 30
Dell#
show pe csp
Display the control and status protocol (CSP) session information for the port extenders.
C9000 Series
Syntax
show pe CSP
Default None
Command Modes
● EXEC
● EXEC Privileged
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage
Information
The following example displays the CSP session information for the port extenders. The command output
shows the following information:
● TxPDUSemStatus shows the next port extender CSP PDU TX state machine status.
● RxPDUSemStatus shows the last port extender CSP PDU RX state machine status.
● LocalReqSemStatus shows the port extender CSP local request state machine status.
Port Extenders (PE) 1359