Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the C9010.
Usage
Information
The Configuration Terminal Batch mode is used to setup common configurations on a port extender
connected in a dual-homing environment. Use the commit command to apply the configuration changes.
In the Configuration Terminal Batch mode, you can continue to commit the changes without exiting the
batch mode.
Example Example with multiple Commits:
Dell#configure terminal batch
Peer is registered
Dell(conf-b)#interface peGigE 184/0/1
Dell(conf-b-if-pegi-184/0/1)#no shutdown
Dell(conf-b-if-pegi-184/0/1)#commit
Dell(conf-b)#Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in
progress
Apr 5 06:48:28: %RPM1-P:CP %IFMGR-5-ASTATE_UP: Changed interface Admin
state to up: PeGi 184/0/1
Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP:
Batch configuration commit is success
Dell(conf-b)#interface peGigE 184/0/1
Dell(conf-b-if-pegi-184/0/1)#switchport
Dell(conf-b-if-pegi-184/0/1)#int vla 1000
Dell(conf-b-if-vl-1000)#tagged peGigE 184/0/1
Dell(conf-b-if-vl-1000)#commit
Dell(conf-b)#Apr 5 06:48:47: %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in
progress
Apr 5 06:48:47: %RPM1-P:CP %IFMGR-5-ACTIVE: Changed Vlan interface state
to active: Vl 1000
Apr 5 06:48:48: %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP:
Batch configuration commit is success
commit write
Use commit write to apply the common configurations made in the Configuration Terminal Batch mode and to save the
running configuration in both VLT peers.
C9000 Series
Syntax
commit write
Parameters None
Default None
Command Modes CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010.
Usage
Information
The Configuration Terminal Batch mode is used to setup common configurations on a port extender
connected in a dual-homing environment. Use the commit write command to apply the configuration
1362 Port Extenders (PE)