Administrator Guide

changes. It also saves the running configuration to the startup configuration in both VLT peers. In the
Configuration Terminal Batch mode, you can continue to commit the changes without exiting the batch
mode.
NOTE: If the commit write command fails on one VLT peer, your configuration is not applied on
both VLT peers.
Example
Primary VLT
DellEMC(conf-b)#int range Tengigabitethernet 3/0 - 5
DellEMC(conf-if-range-te-3/0-5)#mtu 3500
DellEMC(conf-if-range-te-3/0-5)#exit
DellEMC(conf-b)#show conf
interface range tengigabitethernet 3/0 - 5
mtu 3500
DellEMC(conf-b)#commit write
DellEMC(conf-b)#Dec 6 11:31:58 %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in
progress
Dec 6 11:31:58 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied running-config
to startup-config in flash by default
Dec 6 11:31:59 %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP:
Batch configuration commit is success
Dec 6 11:31:59 %RPM1-P:CP %CLIBATCH-6-
CLIBATCH_PEER_CONFIG_WRITE_COMPLETE: Copy of running-config to startup-
config in VLT peer flash is successful
Secondary VLT
DellEMC#Dec 6 10:44:31 %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in
progress
Dec 6 10:44:31 %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP:
Batch configuration commit is success
Dec 6 10:44:31 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied running-config
to startup-config in flash by default
Related
Commands
● commit — apply the common configuration changes made in the Configuration Terminal Batch mode.
discard
Use the discard command to cancel the uncommitted changes made to common configurations in the Configuration Terminal
Batch mode.
C9000 Series
Syntax
discard
Default None
Command Modes CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the C9010.
Usage
Information
The Configuration Terminal Batch mode is used to setup common configurations on a port extender
connected in a dual-homing environment. Use the discard command to cancel the uncommitted
common configuration changes.
Port Extenders (PE) 1363