Administrator Guide

Usage
Information
The on-disable transmit shutdown command allows transmission of LLDP shutdown frames
when the LLDP protocol is disabled in the interface mode.
Example
Dell#sh running-config interface tengigabitethernet 0/1
!
interface TenGigabitEthernet 10/1
no ip address
switchport
switchport mode private-vlan host
!
protocol lldp
on-disable transmit shutdown
no shutdown
Related
Commands
show running-config lldp — displays the LLDP running configuration.
power budget global-threshold
Set a global threshold limit for the PoE power budget on a specified port extender.
C9000 Series
Syntax
power budget global-threshold pe pe-id stack-unit unit number threshold-
value
Parameters
pe pe-id Enter the keyword pe and port extender ID. Range is from 0 to 255.
stack-unit unit
number
Enter the keyword stack-unit and unit number. Range is from 0 to 7.
threshold-value
Enter the power threshold limit value in percentage. Range is from 10 to 99%.
Default value is 99%.
Default None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage
Information
Configure a global threshold limit for the Power over Ethernet (PoE) power budget for a specified port
extender. A default power threshold value of 99% is configured when there is no threshold value
configured.
Use this command in Configuration Terminal Batch mode to configure the threshold limit for the PoE
power budget in a dual-homing setup.
Example
Dell(conf)#power budget global-threshold pe 1 stack-unit 0 99
Dell#show power detail pe 0 stack-unit 0
Unit Total System Redundancy Inline Inline Inline Inline
Inline
Power Power Power Power Power Power Power
Port Extenders (PE) 1381