Administrator Guide

stack-unit unit
number
Enter the keyword stack-unit and the stack unit number Range is from 0 to 7.
interface
interface
Enter the interface keyword, and specify one of the following interface types:
● For a PE Gigabit Ethernet interface, enter the keyword peGigE. You must
specify a pe-id/Unit/Port for the interface.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-
id range is 25 to 28 or 49 to 52 depending on the PE.
Defaults None
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
Usage
Information
The following describes the output fields of the show power inline command:
Field Description
Interface Displays the line card or the port extender interface slot and port number.
Inline Power
Allocated
Displays the amount of power allocated to the port.
Inline Power
Consumed
Displays the amount of power consumed by the connected device.
Class
Displays the power classification of the connected device. If the device is powered
up properly, it displays Class 0, 1, 2, 3, or 4. Displays the following under different
conditions:
● NO_DEVICE if no device is present.
● LEGACY if a legacy device is connected.
● PD_S/C if a short-circuit condition is detected.
● PD_OVRLD if overload condition is detected.
Device Type Displays whether the device is Type 1 or Type 2.
PoE Port Priority Displays the power configured for the port (default is low). See power inline
priority.
LLDP Support Displays the power requested is via LLDP-MED extended power-via-mdi TLV or
IEEE 802.3at power-via-mdi TLV.
Example
Dell#show power inline pe 255 stack-unit 0
Global inline power Threshold : 99
Power Reserved for inline Power: 1612W
Total Inline Power Consumed: 21W
Remaining inline power Available: 1580W
Power Management Mode: Class
Port Extenders (PE) 1387