Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.7.1.0 Introduced on the E-Series.
Related
Commands
monitor session — enables a monitoring session.
erpm
Configure the source and destination IP address for ERPM traffic.
Syntax
erpm source-ip ip-address dest-ip ip-address [gre-protocol value]
To remove the configuration, use the no erpm source-ip IP-address dest-ip IP-address
[gre-protocol value] command.
Parameters
source–ip ip-
address
Enter the keywords source-ip then the source IP address in dotted decimal
format.
destination–ip
ip-address
Enter the keywords dest-ip then the destination IP address in dotted decimal
format.
gre–protocol
value
(OPTIONAL) Enter the keywords gre-protocol then the protocol type value for
ERPM type monitor session. The range is from 1 to 65535.
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Example
Dell(conf-mon-sess-10)#erpm source-ip 10.10.10.1 dest-ip 5.1.1.2 gre-
protocol 1111
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced GRE protocol support.
Port Monitoring 1391