Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1391

Command Modes

● CONFIGURATION

● EXEC

● EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.11(0.0) Introduced the support for GRE Protocol and FC Monitor in the command output.

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.4.0.0 Added support for the RPM / ERPM.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

8.1.1.0 Introduced on the E-Series ExaScale.

7.7.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 Introduced on the E-Series.

Example

Dell#show monitor session 1

SessID Source Destination Dir Mode SourceIP DestIP DSCP TTL Drop Rate Gre-

Protocol FcMonitor

----- ------ ----------- --- ---- -------- ------- ---- --- --- ----

------------ ---------

1 PeGi 0/0/0 Te 10/2 rx Port 0.0.0.0 0.0.0 0 0 0 No N/A N/

A Yes

Commands

monitor session — creates a monitoring session.

show running-config monitor session

Display the running configuration of all monitor sessions or a specific session.

C9000 Series

Syntax

show running-config monitor session {session-ID}

To display the running configuration for all monitor sessions, use the show running-config

monitor session command.

Parameters

session-ID

(OPTIONAL) Enter a session identification number. The range from 0 to 65535.

Defaults none