Administrator Guide

● For a VLAN interface, enter the keyword VLAN and a vlan-id number. Range is
from 1 to 4094.
● For a remote VLAN interface, enter the keyword Remote-VLAN and a vlan-id
number. Range is from 1 to 4094
● For a port channel interface, enter the keyword port-channel and a port-
channel ID.
NOTE: You cannot configure VLAN 4092 and 4093. These VLANs are reserved
for internal use.
range Enter the keyword range to specify the list of interfaces.
destination Enter the keyword destination to specify the destination interface.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keyword port-channel and a the
port-channel ID.
● For a remote VLAN interface, enter the keyword Remote-VLAN and a vlan-id
number. Range is from 1 to 4094
interface Enter the one of the following keywords and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword VLAN and a vlan-id number. Range is
from 1 to 4094.
● For a port channel interface, enter the keyword port-channel amd a the
port-channel ID.
direction {rx | tx
| both}
Enter the keyword direction then one of the packet directional indicators.
● rx: to monitor receiving packets only.
● tx: to monitor transmitting packets only.
● both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Command
History
This guide is platform-specific. For command information about other platforms, see to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.4.0.0 Added support for Source and destination.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
1396 Port Monitoring