Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1391

• switchport mode private-vlan

ip local-proxy-arp

Enable/disable Layer 3 communication between secondary VLANs in a private VLAN.

C9000 Series

Syntax

[no] ip local-proxy-arp

To disable Layer 3 communication between secondary VLANs in a private VLAN, use the no ip local-

proxy-arp command in INTERFACE VLAN mode for the primary VLAN.

To disable Layer 3 communication in a particular secondary VLAN, use the no ip local-proxy-arp

command in INTERFACE VLAN mode for the selected secondary VLAN.

NOTE: Even after you disable ip-local-proxy-arp in a secondary VLAN, Layer 3 communication

may happen between some secondary VLAN hosts, until the ARP timeout happens on those hosts.

Defaults Layer 3 communication is disabled between secondary VLANs in a private VLAN.

Command Modes INTERFACE VLAN

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the C-Series and S-Series.

Commands

● private-vlan mode — sets the mode of the selected VLAN to community, isolated, or primary.

● private-vlan mapping secondary-vlan — maps secondary VLANs to the selected primary VLAN.

● show arp — displays the ARP table.

● show interfaces private-vlan — displays the type and status of the PVLAN interfaces.

● show vlan private-vlan — displays the PVLANs and/or interfaces that are part of a PVLAN.

● switchport mode private-vlan — sets PVLAN mode of the selected port.

private-vlan mode

Set PVLAN mode of the selected VLAN to community, isolated, or primary.

C9000 Series

Syntax

[no] private-vlan mode {community | isolated | primary}

To remove the PVLAN configuration, use the no private-vlan mode {community | isolated

| primary} command syntax.

Parameters

community Enter the keyword community to set the VLAN as a community VLAN.

Private VLAN (PVLAN) 1399