Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1411

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.1 Introduced on the E-Series.

Usage

Information

NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and untagged switched

traffic and for Layer 3 traffic. Per VLAN rate limit and rate police is supported on only tagged ports

with Layer 2 switched traffic.

On one interface, you can configure the rate police command for a VLAN or you can configure the

rate police command for an interface. For each physical interface, you can configure three rate

police commands specifying different VLANS.

Commands

rate-police — specifies traffic policing on the selected interface.

rate shape

Shape the traffic output on the selected interface.

C9000 Series

Syntax

rate shape [kbps] rate [burst-KB]

Parameters

kbps (Optional) Enter the keyword kbps to specify the rate limit in kilobits per second

(Kbps). The range is from 0 to 10000000. The default granularity is Megabits per

second (Mbps).

rate

Enter the outgoing rate in multiples of 10 Mbps. The range is from 0 to 40000.

burst-KB

(OPTIONAL) Enter the burst size in KB. The range is from 0 to 10000. The default

is 50.

Defaults Granularity for rate is Mbps unless you use the kbps option.

Command Modes INTERFACE

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.