Administrator Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced.
Usage
Information
To access this command, enter the class-map command. You can match against only one VLAN ID.
Related
Commands
class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map
(input/output) applied on an interface.
C9000 Series
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name
command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
An aggregate output QoS policy applies to all outbound port traffic. An aggregate output QoS policy can
coexist with per-queue output QoS policies.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
Quality of Service (QoS) 1427