Administrator Guide

wred-profile
Create a WRED profile and name the profile.
C9000 Series
Syntax
wred-profile wred-profile-name
To remove an existing WRED profile, use the no wred-profile command.
Parameters
wred-profile-
name
Enter your WRED profile name in character format (32 character maximum). Or
use one of the pre-defined WRED profile names. You can configure up to 26 WRED
profiles plus the five pre-defined profiles, for a total of 31 WRED profiles.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g, wred_teng_y,
wred_teng_g.
Defaults The five pre-defined WRED profiles. When you configure a new profile, the minimum and maximum
threshold defaults to predefined wred_ge_g values.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.1.1.1 Introduced on the E-Series
Usage
Information
Use the default pre-defined profiles or configure your own profile. You cannot delete the pre-defined
profiles or their default values. This command enables WRED configuration mode —(conf-wred).
Use this command in Configuration Terminal Batch mode to create the WRED profile in a dual-homing
setup.
Related
Commands
threshold — specifies the minimum and maximum threshold values of the WRED profile.
show hardware
This command displays hardware buffer configurations and counters.
C9000 Series
Syntax
show hardware {linecard number | pe-unit number stack-unit number} buffer
unit number port number buffer-info
Parameters
linecard Line card 0 – 11.
1450 Quality of Service (QoS)