Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1451

pe-unit PE-unit is use to specify the PE. PE ID 1 – 255.

stack-unit Stack-unit is used to specify the statck unite in the stacked PE system. Stack-unit

within a PE ID 0 – 7.

buffer-unit Buffer unit is used to specify the port-pipe. Buffer-unit 0 – 0.

Defaults None

Command Modes Exec

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

DSCP Color Map Commands

The DSCP color map allows you to set the number of specific DSCP values to yellow or red. Traffic marked as yellow delivers

traffic to the egress queue which will either transmit the packet if it has available bandwidth or drop the packet due to no ability

to send. Traffic marked as red (high drop precedence) is dropped.

dscp

Sets the number of specific DSCP values for a color map profile to yellow or red.

C9000 Series

Syntax

dscp {yellow | red} [list-dscp-values]

To remove a color policy map profile, use the no dscp {yellow | red} [dscp-list] command.

Parameters

Yellow Enter the yellow keyword. Traffic marked as yellow delivers traffic to the egress

queue which either transmits the packet if it has available bandwidth or drops the

packet due to no ability to send.

red Enter the red keyword. Traffic marked as red is dropped.

dscp-list

Enter a list of IP DSCP values. The dscp-list parameter specifies the full list of IP

DSCP value(s) for the specified color. Each DSCP value in a list is separate values

by commas – no spaces (1,2,3) or indicates a list of values separated by a hyphen

(1-3). Range is 0 to 63.