Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage
Information
If the specified color-map does not exist, the Diffserv Manager (DSM) creates a color map and sets all
the DSCP values to green (low drop precedence).
The default setting for each DSCP value (0-63) is green (low drop precedence). This command allows
setting the number of specific DSCP values to yellow or red.
Important Points to Remember
● All DSCP values that are not specified as yellow or red are colored green.
● A DSCP value cannot be in both the yellow and red lists. Setting the red or yellow list with any DSCP
value that is already in the other list results in an error and no update to that list is made.
● Each color map can only have one list of DSCP values for each color; any DSCP values previously
listed for that color that are not in the new DSCP list are colored green.
Example
Dell(conf-dscp-color-map)# dscp yellow 9,10,11,13,15,16
Related
Commands
qos dscp-color-map — configures the DSCP color map
qos dscp-color-policy— configures a DSCP color policy
qos dscp-color-map
Configure the DSCP color map.
C9000 Series
Syntax
qos dscp-color-map map-name
To remove a color map, use the no qos dscp-color-map map-name command.
Parameters
map-name Enter the name of the DSCP color map. The map name can have a maximum of 32
characters.
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
1452 Quality of Service (QoS)