Administrator Guide

Version Description
6.2.1.1 Introduced on the E-Series.
Usage
Information
Although the passive interface does not send or receive routing updates, the network on that interface
still includes in RIP updates sent using other interfaces.
Related
Commands
neighbor — enables RIP for a specified network.
network — defines a neighbor.
redistribute
Redistribute information from other routing instances.
C9000 Series
Syntax
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
connected Enter the keyword connected to specify that information from active routes on
interfaces is redistributed.
static Enter the keyword static to specify that information from static routes is
redistributed.
Defaults Not configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
To redistribute the default route (0.0.0.0/0), configure the default-information originate
command.
Related
Commands
default-information originate — generates a default route for RIP traffic.
Routing Information Protocol (RIP) 1495