Administrator Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
To enable RIP, assign a network address using the network command.
Example
Dell(conf)#router rip
Dell(conf-router_rip)#
Related
Commands
network — enables RIP.
exit — returns to CONFIGURATION mode.
show config
Display the changes you made to the RIP configuration. The default values are not shown.
C9000 Series
Syntax
show config
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
Dell(conf-router_rip)#
1498 Routing Information Protocol (RIP)