Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
line — applies an authentication method list to the designated terminal lines.
ip access-list standard — names (or selects) a standard access list to filter based on the IP address.
ip access-list extended — names (or selects) an extended access list based on the IP addresses or
protocols.
enable password
Change the password for the enable command.
C9000 Series
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type] password [level
level] command.
Parameters
level level (OPTIONAL) Enter the keyword level then a number as the level of access. The
range is from 1 to 15.
encryption-type
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 then a text string as the hidden password. The text string must be a
password that was already encrypted by a Dell Networking router.
Use this parameter only with a password that you copied from the show
running-config file of another Dell Networking router.
password Enter a text string, up to 32 characters long, as the clear text password.
Defaults No password is configured. level = 15.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Neworking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
1520 Security