Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch
1531153215331534153515361537153815391540
Command Modes
● CONF-DYNAMIC-AUTH
Usage
Information
● Optionally specify dynamic authorization port number. Default port is 3799.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
radius dynamic-auth
Enters a new sub-mode, RADIUS-DYNAMIC-AUTH, which enables you to modify dynamic authorization settings.
Syntax
radius dynamic-auth
To remove the dynamic authorization method for RADIUS users, enter the no radius dynamic-auth
command.
Defaults Disabled.
Command Modes
● CONFIGURATION
Usage
Information
● All dynamic authorization commands are configured by entering this mode.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
radius-server deadtime
Configure a time interval during which non-responsive RADIUS servers to authentication requests are skipped.
C9000 Series
Syntax
radius-server deadtime seconds
To disable this function or return to the default value, use the no radius-server deadtime
command.
Parameters
seconds
Enter a number of seconds during which non-responsive RADIUS servers are
skipped. The range is from 0 to 2147483647 seconds. The default is 0 seconds.
Defaults 0 seconds
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Security 1539