Administrator Guide

ip ssh server dns enable
Enable or disable the DNS in SSH server configuration to resolve hostname for host-based authenticatioin.
Syntax
ip ssh server dns enable
To disable the DNS in SSH server configuration, use the no ip ssh server dns enable command.
Defaults
Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.13.0.1 Introduced on the MXL, C9010, S3048–ON, S3100 series, S4810, S4820T, S4048–
ON, S4048T-ON, S5000, S6000, S6000–ON, S6100–ON, S6010–ON, Z9500,
Z9100–ON and FN-IOM.
Usage
Information
To disable the DNS in SSH server configuration, use the no ip ssh server dns enable command.
ip ssh source-interface
Specifies an interface’s IP address as the source IP address for an outgoing SSH connections.
C9000 Series
Syntax
ip ssh source-interface interface
To delete a source interface, use the no ip ssh source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For Loopback interfaces, enter the keyword loopback then a number from
zero (0) to 16838.
● For the Null interface, enter the keywords null 0.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.5(0.1) Introduced on the Z9500.
Security 1575