Administrator Guide

Version Description
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
The source-interface interface attribute is applicable for both the SSH client as well as the
COPY (SCP) commands. Using these attributes the client session tags an error to the user during run
time, in case there is a mismatch between this command and the ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 0/36
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface
show crypto
Display the public part of the SSH host-keys.
C9000 Series
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more information,
contact your Dell Networking representative.
show crypto key mypubkey {rsa | rsa1}
Parameters
Key Enter the keyword key to display the host public key.
mypubkey Enter the keyword mypubkey to display the host public key.
rsa Enter the keyword rsa to display the host SSHv2 RSA public key.
rsa1 Enter the keyword rsa1 to display the host SSHv1 RSA public key.
NOTE: If you enable FIPS mode, this parameter is not available.
Defaults none
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
This command is useful if the remote SSH client implements Strict Host Key Checking. You can copy the
host key to your list of known hosts.
Example
Dell#show crypto key mypubkey rsa
ssh-rsa AAAAB3NzaC1yc2EAAAABIwAAAIEAtzkZME/
e8V8smnXR22EJGQhCMkEOkuisa+ OILVoMYU1ZKGfj0W5BPCSvF/
1576 Security